KTMUPGRADES Custom decal set no 19 for RC 125/200/390

4.00 out of 5 based on 5 customer ratings
(5 customer reviews)
4,899.00 3,999.00

KTMUPGRADES Graphics are produced to order and may take up to 5 business days to produce. All graphics are digitally printed with UV resistant inks that are guaranteed not to fade up to 5 years. Genuine 3M brand adhesive assures your graphics won’t be peeling…

4 in stock



All kits are custom printed to order and take 5 to 7 business days to produce.

  • Triple layer laminated 3M industrial adhesive.
  • Thickest Graphics on the Planet! 22-25mil thick!
  • UV Coated. No fade 5 year guarantee.
  • Install instructions included.
  • Made in INDIA.



Use a blow dryer or heat gun to heat older decals and help peel them off. For any remaining glue you can still heat up a bit and rub off or use goo gone, rubbing alcohol or any similar residue/glue remover.

Tools Needed: Squirt bottle with water, squeegee (old credit card works well), soft cloth and scissors, heat gun or blow dryer.

Install in room temperature. Do not rush the install.

  1. Thoroughly clean all surfaces with soap and water and remove all old adhesive, dirt, lint, oils etc. Rinse well with plain water and dry with lint-free cloth. Use rubbing alcohol or Goo Gone for any residue of old adhesive. Heating up old adhesive also helps in removal. If you use Goo Gone make sure you clean your plastics again with soap and water.
  2. Before removing decal backing, hold decals up to to your vehicle to get a general idea of how the graphics should look and where all the pieces go.
  3. Wrap a soft, lint free cloth around your squeegee.
  4. Spray the plastic you are going to work on first with water. Coat the entire outside surface.
  5. Slowly peel the backing from the decal piece, and as you peel, spray light mist of water to the adhesive side of the decal.
  6. Lightly set the decal onto the plastic making sure everything lines up properly. Start at one end of the decal and squeegee the water out of the other end.
  7. Use heat just enough to soften the vinyl for intricate curves. When using a heat gun or blow dryer be careful not to burn the kit.
  8. Repeat the above with all other pieces.
  9. Use the heat gun or blow dryer and lightly heat the whole install to help the vinyl set in form.


Weight 1 kg

5 reviews for KTMUPGRADES Custom decal set no 19 for RC 125/200/390

  1. jason francis
    5 out of 5

    is this available for rc 200?

  2. Deepak Chauhan
    4 out of 5

    I need it for RC 200, How to specify same same during order placement as in pic 390 is shown.

    • Tarak Makwana

      no need to specify as 200 or 390 is not written on the decals

  3. Kevin
    1 out of 5

    does it work on the 2018 model of ktm rc?

  4. Kevine
    5 out of 5

    Is it possible to use this decal for the 2018 rc model?

  5. Jude Shakeshaft
    5 out of 5

    Can I have the 125 version? And can it be shipped to the uk?

Add a review